Zodiac Online Catalog
Search our website
Products
Searching...

Wishlist

{{articleCount}} 0 {{articleString}} Articles
Previous Product
DELCO TYPE VOLTAGE REGULATOR

DELCO TYPE VOLTAGE REGULATOR

CYCLE ELECTRIC GENERATOR FITTED VOLTAGE REGULATORS

Next Product
CUSTOM STYLE GENERATOR FITTED REGULATOR

CUSTOM STYLE GENERATOR FITTED REGULATOR

These electronic regulators replace the end bell and become a structural part of the generator. The current limiting circuit senses armature temperature and adjusts available output to allow for maximum amperes without overheating the armature. This gives you more power for faster battery recharging and cooler operation for longer generator life. Can also be used without battery. Will not fit some models with foot clutch. Installation on FL models with an OEM pre-1992 or aftermarket generator with the fins level with the motor requires the separate purchase of the ZPN 782246 end plate.


Specifications

Article number Description Retail price Add to list
782318 Fits any Model 65A 12 Volt generator. Must be used with 7AH or more battery € 245,87
782319 Fits any Model 65A 12 Volt generator, tuned for a 5.5AH battery in 6-volt oil tank € 245,87
782246 Optional end plate to install 12 volt regulator with the fins level on FL models € 53,66
782320 Fits any Model 61 2-brush 6 volt generator € 253,03 € 152,20

Recommended Retail Prices excluding sales tax.

Prices exclude shipping, import duties and installation.

Polarizing generators and regulators
The following information and instructions are for your use, so your warranty will by in effect. No warranty can be in effect if these instructions are not followed. Whenever any component of a generator charged electrical system is serviced it is necessary to re-polarize the complete system, making sure it has the correct polarity so the system will charge in the right direction. If the system is put into service with the wrong polarity it may result in burned relay points, a dead battery and damage to both the regulator and generator.
Instructions:
1. To polarize a generator system with a mechanical regulator, momentarily connect a jumper wire of adequate gauge (a battery cable is ideal) between the “bat” and the “gen” terminal on the regulator after all wires have been properly connected and before starting the motor.
2. To polarize a generator system with electronic regulator/ rectifier. Before mounting the generator of the vehicle, place the generator on a non conducting work surface (like a wooden bench) and connect the positive terminal of a battery to the armature terminal of the generator. Then momentarily “flash” the negative battery terminal to the generator field terminal.